BegerLite 365 Primer B-1999

• New plaster primer (oil formula)
• Premium grade
• Application area 35-40 sq.m./gallon/time

• Easy to apply, has a lot of space
• Good adhesion to the floor, not peeling off
• Prevents and inhibits the growth of fungi and algae well.
• Protects against salt stains.

  ราคาขึ้นอยู่กับเฉดสีแต่ละเฉด โปรดเลือกเฉดที่ต้องการ ได้ที่ กด " ดูเพิ่ม " จะพบแคตตาล๊อก ติดต่อสอบถามราคา  083-2393626  ,  083-2396466  หรือ  LINE : @TOPAINTS   

• Step 1 Surface preparation

• • New plastered surfaces: Make sure the surfaces are dry, clean and free of dust and dirt.
  • Cracked surfaces: remove bricks and stones around the cracks, enlarge the cracks appropriately. then fill the cracks With a grooved filler, let it dry and smooth it with sandpaper. and clean
  • Surface with original color: Remove the original paint that has peeled off. With a scraping trowel or wire brush, if unsure of the condition of the original paint Peel it off with a tool. or Beyer paint remover Then clean thoroughly with high-pressure water jets. and leave to dry completely before painting.
  • Moldy surfaces: Remove algae, mold with scraping trowels or wire brushes followed by high-pressure water jets. Then clean the surface too. Beyer Mold Free Mold Free M-001

• Step 2 Primer paint 

• • In case of new cement surfaces or old cement surfaces with normal humidity values (humidity is lower than Approximately 20%), apply foundation as well. Begerlight Primer B-1999, 1 coat to increase the ability to adhere to the surface. and efficiency in protecting the occurrence of stains from salt
  • In case of new cement surfaces or old cement surfaces with higher humidity than normal (humidity range 20-35% approximately) or a surface that has accumulated moisture continuously. It is also recommended to apply Beyerlight Waterroof Primer No. 1012, 1 coat before applying topcoat.

• Step 3 Topcoat paint 

• • After applying the primer, allow it to dry for at least 24 hours. 2 coats of Beger Light 365, each coat should be left to dry for at least 24 hours.

• First coat: Begerlight 365 should be diluted with approximately 10% Begerlight 365 Thinner M-91 for better penetration and adhesion. and make the color last longer
• Second coat : Apply Beger Light 365 without dilution.